ANT 3 Antenna for 2700T&B and EDGE Series: Fit and Replacement

Start with the transmitter model, not the antenna label

The ANT 3 antenna is a replacement part, so the model printed on your Dogtra transmitter decides whether it belongs in your kit. The supplied catalog record lists compatibility with these handhelds: 1900X BLACK EDITION, 1900S BLACK, 1900S BLACK EDITION B&L, EDGE, EDGE RT, 2700 T&B, 2702 T&B, 3500NCP, and 3502NCP.

If you run a 2700T&B or an EDGE series transmitter, this antenna is the version to check against your unit. If your transmitter is a different model, stop there and match the part to your actual handheld rather than ordering by appearance.

What the ANT 3 antenna is listed to fit

• ANTENNA ANT 3 _2700T&B SERIES, EDGE SERIES: Compatible with transmitter models: 1900X BLACK EDITION, 1900S BLACK, 1900S BLACK EDITION B&L, EDGE, EDGE RT, 2700 T&B, 2702 T&B, 3500NCP, 3502NCP. This is the compatibility list to compare with the model name on your own transmitter before you buy or swap the antenna.

  

How to replace the transmitter antenna

The supplied record confirms the antenna's compatible transmitter models but does not include a separate removal or installation procedure. Use the steps below as a practical handling sequence, and follow any instructions that came with your transmitter or antenna if they differ.

1. Power the transmitter off: Turn the handheld off before you handle the antenna so you are not making changes while the unit is active.
2. Match the model before removing anything: Read the model name on the transmitter and compare it with the supplied compatibility list. This is the checkpoint that prevents buying or fitting the wrong antenna.
3. Remove the old antenna carefully: Work at the antenna base rather than pulling on the tip. The supplied information does not describe a specific removal method, so avoid forcing any part that does not move freely.
4. Fit the ANT 3 antenna: Seat the replacement antenna at the same connection point. Do not cross-thread or over-tighten; the supplied record does not provide a torque value or tool requirement.
5. Check the fit before your next session: Confirm the antenna is secure and the transmitter powers on normally. If anything feels loose or unusual, stop and check the connection again before heading out.

Fit checks worth making before you order

• Your handheld model: The 2700 T&B, 2702 T&B, EDGE, and EDGE RT are named in the supplied compatibility list. A transmitter outside that list is not confirmed as compatible.
• The part you are replacing: The ANT 3 antenna is listed as a transmitter antenna. The supplied record does not confirm receiver-side use, so keep the replacement to the handheld.
• What the record does not state: The supplied information does not include antenna length, gain, connector type, or a range claim. Treat any such figure you see elsewhere as unverified until you confirm it with the manufacturer.

Where the ANT 3 antenna makes sense

This is a sensible spare if you already own one of the listed transmitters and want a replacement antenna on hand. The catalog price is USD 7.50 against a comparison price of USD 14.99, so the part is inexpensive enough to keep as a backup rather than waiting for a failure mid-season.

It is not a universal antenna. If your transmitter is not on the compatibility list, the honest answer is that the supplied information does not confirm a fit, and you should verify your model before ordering.